Visonic PowerMax10 Guía de usuario descargar pdf (Pagina 14)

REVIEWING TROUBLES AND ALARM MEMORY

D-302757 13

Fault What it means

The control panel cannot configure or control the device.

Battery consumption increases.

A device was not installed or not installed correctly, or, cannot

establish communication with the control panel after installation.

A device or detector has not reported for some time to the

control panel.

A radio-frequency signal which is blocking communication

channel of sensors and control panel is detected.

The battery in a sensor, keyfob or wireless commander is near the

end of its useful life.

The fire detector must be cleaned

Gas detector failure

There is no power to the siren

There is no power to gas sensor

The GSM communicator is not able to connect to the cellular

network.

The GSM communicator has detected that GSM network signal is

weak

There is no power and the system is working on backup battery

power

A message could not be sent to the monitoring station or to a

private telephone (or a message was sent but was not

acknowledged)

The backup battery within the control panel is weak and must be

replaced (see Chapter 7 - Replacing Backup Battery).

The control panel was physically tampered with or its cover was

opened, or it was removed from wall.

The PGM fuse is burnt out or overloaded.

There is a problem with the telephone line

LINE FAILURE

FUSE TROUBLE

CPU TAMPER

CPU LOW BATTERY

COMM. FAILURE

AC SUPPLY FAILURE

SSI LOW

GSM NET FAIL

AC FAILURE

SIREN AC FAILURE

GAS TROUBLE

CLEAN ME

LOW BATTERY

JAMMING

MISSING

NOT NETWORKED

1-WAY

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Comentarios a estos manuales

Sin comentarios

Visonic PowerMax10 Guía de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Visonic PowerMax10