Visonic AMBER SELECT Guía de usuario descargar pdf (Pagina 34)

6-4____________________________________________________________Data Table Details

Ringback Time – Here you determine the period during which the central station can

establish 2-way voice communication with the Amber Basic PC Remote Programmer (after

1 ring), if an alarm type message was received by central station or the Ringback function

was selected. Options: 1 minute, 3 minutes, 5 minutes or 10 minutes.

Central Station Dialing Attempts – You can either enable or disable the voice prompts and

messages sent to the central station.

Private Tel. No. – You type the number of the first private telephone to which the

system will report events.

Private Tel. No. – You type the number of the second private telephone to which the

system will report events.

Private Tel. No. – You type the number of the third private telephone to which the

system will report events.

Private Tel No. – You type the number of the fourth private telephone to which the

system will report events.

Voice Session - Private Phones – You can either enable or disable the voice prompts and

messages sent to private phones. Options: Enable or Disable.

Private Telephone Dialing Attempts – The number of attempts that Amber Basic PC

Remote Programmer will make to establish communication with private telephone

subscribers. Options: 1 attempt, 2 attempts, 3 attempts or 4 attempts.

Reporting to Private Telephones – The events that Amber Basic PC Remote Programmer

will report to private telephone numbers. Alerts and Disable Report.

Private Telephone Acknowledge – The private telephone report acknowledge mode. There

are two modes:

Single Acknowledge - When the Control Panel receives an acknowledge signal from one

private telephone subscriber, it considers the current event closed. The remaining

acknowledge signals are for backup purposes only.

All Acknowledge - The Control Panel must receive an acknowledge signal from all private

telephone subscribers in order to consider the current event closed.

Remote Access – Determines permission to access and modify the Control Panel from a

remote telephone. Options: On and Off.

Dialing Method – The dialing method used by the Amber Basic PC Remote Programmer

automatic dialer. Options: Tone (DTMF) and Pulse.

Line Failure Report – Here you determine if the telephone line disconnection will be

reported or not and determine the delay between detection of line disconnection and the

failure reporting. If the telephone line is disconnected, the message "tel line fail" will be

stored in the event log. Options: Don't Report, Immediately, 5 Minutes, 30 Minutes, 60

Minutes or 180 Minutes.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 58 59

Sin comentarios

Visonic AMBER SELECT Guía de usuario Pagina 34