Visonic POWERMASTER-10 - INSTALLER GUIDE Guía de usuario descargar pdf (Pagina 12)

OPERATING THE POWERMASTER SYSTEM

D-303223 PowerMaster-10/30 G2 User's Guide 11

Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit

delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.

If forced arming is enabled and you wish to arm the system when NOT READY is displayed, proceed as shown:

PRESS

RESULTING DISPLAY

ENTER CODE _ _ _ _

[Enter code]

Code

ARMING AWAY

PLEASE EXIT NOW

(to mute the buzzer)

Vacate the premises

 (Exit delay)



AWAY

ARM indicator lights during the armed state.

Remember: Forced arming compromises security!!

Forced arming “HOME” is performed in a similar manner, as follows:

PRESS

RESULTING DISPLAY

ENTER CODE _ _ _ _

[Enter code]

Code

ARMING HOME

PLEASE EXIT NOW

(to mute the buzzer)

Go to interior zone

 (Exit delay)



HOME HH:MM

ARM indicator flashes during the armed state.

Arming in the Latchkey Mode

This mode, if enabled by the installer, is useful for a parent at work who wants to be sure that his children have

returned from school and have disarmed the system. A special “latchkey” message will be sent out when the

system is disarmed by a “latchkey user”.

Latchkey users are holders of user codes or users of keyfob transmitters 5 through 8 (PowerMaster-10 G2) /

user codes 23-32 (PowerMaster-30 G2). The latchkey message is considered an alert and not an alarm, and is

therefore sent to the private telephones programmed by the user as targets for alert messages.

Latchkey arming is possible only when you arm “AWAY”. To arm in the Latchkey mode, proceed as follows:

PRESS

RESULTING DISPLAY

ARMING AWAY

ARMING LATCHKEY

(Within 2 seconds)

(alternating)

PLEASE EXIT NOW

Vacate the premises

 (Exit delay)



AWAY

Note: Latchkey must be enabled by your installer.

ARM indicator lights during the armed state.

Initiating Alarms

Following are various methods that may be used for initiating alarms.

Initiating Panic Alarm

You can generate a panic alarm manually in the disarmed and armed states. The sequence will be as shown:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 61 62

Comentarios a estos manuales

Sin comentarios

Visonic POWERMASTER-10 - INSTALLER GUIDE Guía de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Visonic POWERMASTER-10 - INSTALLER GUIDE