Visonic POWERMASTER-10 - INSTALLER GUIDE Guía de usuario descargar pdf (Pagina 19)

MENUS AND FUNCTIONS

18 D-303223 PowerMaster-10/30 G2 User's Guide

6. Menus and Functions

This chapter explains the user programming features of your PowerMaster system and allows you to tailor the

PowerMaster system according to your specific needs. The chapter is divided into three sections, as follows:

Part A – Guides you how to enter/exit the User Settings menu and how to select the desired setting options.

Part B – Guides you to execute the selected settings.

A.1 Entering the User Settings Menu & Selecting a Setting Option

The following procedure describes how to enter and move within the User Settings menu.

Detailed descriptions of the User Settings options are provided at the end of the procedure.

To exit the User Settings menu – see section B.2.



1. You can enter the "USER SETTINGS" menu only when the system is disarmed.

2. Carefully read the section titled "Additional Information" according to the indicated references

etc – see

table at end of this section.

Note: This manual displays PowerMaster-10 G2 control panel buttons only, even when instructions refer to both

control panels. When an instruction refers to PowerMaster-30 G2 only, the PowerMaster-30 G2 control panel

buttons are displayed.

A. To Enter the USER SETTINGS Menu

Make sure the system is disarmed and then press the button

repeatedly until the display reads [USER SETTINGS].

Press

The screen will now prompt you to enter your user code.

CODE

Enter your User Code.

The display reads the first Setting option of the User Settings menu

[SET BYPASS].

B. To Select a Setting Option

Click the or button until the display reads the desired setting

option, for example, "TIME & FORMAT".

When the desired setting option appears on the display, press the

button to enter the setting process.

Continue to the selected

setting option in B.1 - B.14

The remainder of the procedures for the selected setting options is provided in

sections B.1 to B.14.

Additional Information (section B.1)

Display shown in disarm state when all zones are secured (00:00 or other digits show present time).

a. If you have not already changed your personal code number, use the default setting – 1111.

b. Master User has access to all User Settings options. Other users have access only to the Bypass options.

c. Do not set any user code the same as an installer code.

d. If you enter an invalid user code 5 times, the keypad will be automatically disabled for a pre-defined

period of time and the message WRONG PASSWORD will be displayed.

The bypass options will be displayed in the User Settings menu only if enabled by the installer. Otherwise,

the first User Settings option displayed will be [

USER CODES

READY 00:00

USER SETTINGS

ENTER CODE:



SET BYPASS

TIME & FORMAT

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 61 62

Comentarios a estos manuales

Sin comentarios

Visonic POWERMASTER-10 - INSTALLER GUIDE Guía de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Visonic POWERMASTER-10 - INSTALLER GUIDE